Heating cables

Heating cables+1

Põrandaküttekaabel 20W/m sobib betoonpõranda soojendamiseks vannitoas, esikus ja eluruumis, kus betoonvalu paksus on ca 3–5 cm. Õhema põranda korral on parem valik põrandaküttematt. Elektriline põrandaküte eeldab hästi soojustatud põrandat, et küttekaabel töötaks tõhusalt ja säästlikult. Heatcom põrandaküttekaabel on tugev, 5 mm läbimõõduga ja vastupidav lahendus. Sama küttekaabel sobib ka kasvuhoonesse, külmhoonesse, treppi ja välialale, kui ei ole nõutud UV-kindlust.

Heating cables+1

The water pipe heating cable is specially designed for installation in and on the water pipe 10W/m. The water pipe heating cable Heatcom Aqua Safe is equipped with a connector for quick and convenient installation. The heating cable is certified for drinking water. In the case of a sewer pipe, installation is only on the pipe. When installing inside the water pipe, choose the insert nipple as a set and don't forget the thermostat. Read more about installation below. Lengths: 1m, 2m, 4m, 6m, 8m, 10m, 12m, 14m, 16m, 18m, 20m, 22m, 24m, 30m, 40m

Heating cables+1

The thin pipe heating cable Kima Green (8 W/m) is a reliable solution for protecting water pipes from freezing. It is officially approved for use in direct contact with drinking water. Thanks to its small diameter (5.5 mm), the heating cable is ideal for installation inside pipes without obstructing the water flow. It is also highly suitable for external installation on sewage and drainage pipes.

Heating cables+1

Gutter and rainwater heating cable Heatcom 30W/m – designed for keeping downpipes, roof valleys, and roof edges free of ice and snow. Heatcom heating cables are manufactured in Denmark; they are high-quality, specially designed for outdoor use, and feature high tensile strength. The weatherproof gutter heating cable is equipped with a 2.5m power cable on one end. We offer a great selection of fasteners for the correct installation of heating cables on the roof. See the picture gallery below. Note: For smaller installations, we recommend a ready-made gutter cable with an integrated thermostat.

Heating cables+1

Outdoor heating cable 30W/m for melting ice and snow on driveways, sidewalks, ramps, and stair steps to make it safe to walk there. The heating cable is installed either in concrete, limestone dust, cold asphalt or a layer of sand. The heating cables are installed to a depth of approximately 3-7cm. The outdoor heating cable is weatherproof and can also be used in gutters.

Heating cables+1

Roof heating cable 20W/m for SBS / PVC roofs The outdoor and roof heating cable with an output of 20W/m is designed for long-term outdoor use. This heating cable is perfectly suitable for use on bitumen, SBS, and PVC-coated roofs, where a lower heating cable output per linear meter is required compared to metal roofs. However, it is important to remember that keeping a 120mm gutter and downspout completely ice-free requires an output of 30-40W per meter. To achieve this capacity, the 20W/m heating cable must be installed back-and-forth (in a loop).

Heating cables+2

Self-regulating heating cable from HTS eHeat Water – preassembled set 11W/m, designed for protecting water pipes from freezing, suitable for both internal and external installation. The self-regulating pipe heating cable comes with a 1.5m power cable. For internal pipe installation, a separate insertion nipple for the heating cable must be purchased. Certified for drinking water! The most energy-efficient result is always achieved when used together with a thermostat.  

Heating cables+3

The HTS eHeat Gutter self-regulating heating cable (20W/m) provides reliable ice and frost protection. It is a professional solution for protecting gutters, downspouts, and external sewage pipes from freezing. The system effectively prevents the formation of ice dams and damage to utilities even at temperatures dropping to -30 °C. The cable is supplied as a ready-to-use kit with a plug, making installation as simple and fast as possible. ✅ Efficiency: Automatically adjusts its power output depending on the ambient temperature. ✅ Versatility: Suitable for roofs, rainwater systems, and Ø110 mm sewer pipes. ✅ Economy: For maximum reduction in electricity costs, we highly recommend using the cable together with a thermostat.

Heating cables+2

HTS EHEAT® WATER is a self-regulating heating cable for protecting water pipes from freezing. Its food-safe outer jacket is approved for installation inside drinking water pipes. The cable can also be installed on the outside of a pipe beneath insulation. The cable can be cut to the required length, and its heat output adjusts to temperature. A thermostat is recommended to switch the heating off when frost protection is no longer needed. For installation inside a pipe, use a suitable cable entry gland and connection accessories.

Heating cables+2

HTS Global eHeat Gutter is a self-regulating heating cable designed to prevent ice formation on roofs, gutters, downpipes and drainage systems. Its UV-resistant and moisture-proof outer jacket makes it suitable for outdoor installations, including SBS bitumen roofs. The cable provides 20 W/m at +10 °C on an insulated metal pipe and approximately 40 W/m at 0 °C in ice water. It operates at 230 V, has a maximum operating temperature of +65 °C when energised and withstands temperatures up to +85 °C when unpowered. The cable can be cut to the required length on site. A suitable thermostat or automatic snow and ice controller should always be used to reduce energy consumption and prevent unnecessary heating.

Heating cables+1

Vihmaveerenni küttekaabel integreeritud termostaadiga Heatcom Gutter Safe – valmiskomplekt on sobilik kasutamiseks vihmaveerenni ja katusele jäätumise ja jääpurikate tekkimise vältimiseks väiksemate paigaldiste puhul. Iga rennikaabel on varustatud bimetall termostaadiga parema energiasäästu saamiseks

Heating cables+1

Soojenduskaabel firmalt Heatcom on tugeva konstruktsiooniga ja loodud välitingimustes kasutamiseks ja paigaldamiseks otse kuuma asfaldi segusse Küttekaablite toitejuhtmed ja ühendused tuleb paigaldada kaitsetorustikku enne kuuma asfaldiga katmist Asfaldi küttekaabel on mõeldud kiireks ja lihtsaks paigalduseks otse asfaldi alla ja loodud jää ja lume sulatamiseks teedel

Heating cables+2

The concrete curing heating cable is specially designed to heat concrete and accelerate the hardening process and prevent the mixture from freezing during the winter months. The concrete curing heating cable has a 230V supply voltage and an integrated earthed plug.

Heating cables+2

Sigmian BTX is an ATEX-certified high-temperature self-regulating industrial heating cable for frost protection and temperature maintenance on pipelines, tanks and process equipment. Available power outputs at +10 °C are 8, 15, 30, 45, 60, 75 and 100 W/m. The cable operates at 230 V. Its maximum continuous operating temperature is +205 °C when energised, while the maximum exposure temperature when de-energised is +250 °C. BTX is suitable for both non-hazardous and hazardous Ex areas. Its parallel construction allows the cable to be cut to the required length on site. A suitable thermostat must be used for accurate temperature control, lower energy consumption and longer cable life.

Heating cables+2

Sigmian CTE is a high-output, ATEX-certified self-regulating industrial heating cable for heating outdoor areas, concrete, pipelines and vessels. It is primarily intended for applications where a standard-output self-regulating cable does not provide sufficient heating capacity. The Sigmian product page specifies an output of 80 W/m. The technical datasheet gives the 90-CTE model a nominal output of 90 W/m at 0 °C when installed in concrete. The maximum continuous operating temperature when energised is +80 °C, while the maximum continuous exposure temperature when de-energised is +100 °C. The heating cable operates at 230 V and is suitable for both non-hazardous and hazardous Ex areas.

Heating cables+2

Sigmian HTP is an ATEX-certified self-regulating industrial heating cable for freeze protection and temperature maintenance of pipelines, tanks and process equipment. The heating cable is suitable for both non-hazardous and hazardous Ex areas. The cable adjusts its power output according to the surrounding temperature, producing more heat in colder areas and less in warmer areas. Its parallel construction allows the cable to be cut to the required length on site. Always use the heating cable with a suitable thermostat.

Heating cables+3

Powerful high-temperature PTFE heating cable is a splash-proof , heat-resistant , and exceptionally flexible heating cable specifically designed to operate in demanding conditions and withstand high temperatures (up to 260°C) . This powerful heating cable provides wide-area heat transfer , is equipped with protective conductor braiding , and features a factory-fitted 1-meter main connection cable with an M20 x 1.5 screw connection for safe and reliable installation

Heating cables+2

The high-temperature flat heating cable, also known as heating tape, is designed for heating and maintaining the temperature of machine parts, industrial equipment, pipework and laboratory installations. The maximum permissible temperature of the fibreglass-insulated heating element is +450 °C, while its rated output is approximately 250 W/m. Unlike a conventional round heating cable, the 35 mm wide flat construction provides a larger contact area with the heated object. This allows heat to be transferred over a wider surface and makes the heating tape suitable for applications requiring high output per metre and high temperature resistance. The heating cable can be used for pipes, valves, vessels, machine components, test equipment and various process structures. The length, rated voltage and power output are selected according to the requirements of the application.

Heating cables+1

Kõrge temperatuuriga küttekaabel tööstusele metallkestas, keskkonda, kus on vaja hoida või taluda kõrgeid temperatuure. Kuni +800°C

Heating cables+1

If you are looking for heating cables that can withstand even the most demanding conditions, the Sigmian SNF Teflon-coated PTFE heating cable is the perfect choice. This highest-quality heat-resistant heating cable is specifically designed for applications requiring exceptional thermal stability and chemical resistance. The Teflon coating (PTFE) gives the cable the unique ability to repel chemicals and endure extreme heat, making it the preferred choice among engineers and technicians.

Heating cables+2

Kõrge temperatuuriga küttekaabel 250W/m koos termostaadiga pakub täpset temperatuuri reguleerimist kuni 400°C, muutes selle ideaalseks kõrgtemperatuurilisteks tööstus- ja laborirakendusteks. Antud küttekaabel tagab kiire, usaldusväärse ja tõhusa soojuse ka nõudlikes keskkondades.

Heating cables+2

Suure võimsusega küttekaabel 50W/m ja termostaat 0-200°C – tagavad usaldusväärse ja tõhusa soojuse mitmesugustes tööstuslikes ja laboratoorsetes rakendustes. See suure võimsusega küttekaabel pakub optimaalset temperatuuri kontrolli protsessides, ühtlast kuumutamist, näiteks torude, pumpade ja ventiilide õige temperatuuriga tööreziimide tagamine, kemikaalide käitlemine ja temperatuuritundlike vedelike töötlemine.

Heating cables+2

Sigmian BTC is an ATEX-certified high-temperature self-regulating industrial heating cable designed for frost protection and temperature maintenance on pipelines, tanks and process equipment. Available power outputs at +10 °C are 8, 15, 24, 30, 37, 45 and 60 W/m. The cable operates at 230 V. Its maximum continuous operating temperature is +120 °C when energised, while the maximum exposure temperature when de-energised is +200 °C. BTC is suitable for both non-hazardous and hazardous Ex areas. Its parallel construction allows the cable to be cut to the required length on site. A suitable thermostat should always be used for accurate temperature control, lower energy consumption and longer cable life.

Heating cables+2

The portable water pipe frost protection wrap Heatcom Heating Wrap is a ready-to-use solution for preventing water and drain pipes from freezing on construction sites and in temporary installations. The wrap combines a self-regulating 15 W/m heating cable with built-in thermal insulation. The portable water pipe heater is wrapped around the pipe and secured with a hook-and-loop fastening. Once installed, it is connected to the power supply. The product is easy to remove, relocate and reuse.